NAD PP2e Phono Preamplifier
NAD PP2e Phono Preamplifier
A Phono Preamplifier is required if your amplifier or receiver does not have a phono input. The NAD PP2e is also a solid upgrade from the built in Phono input on most receivers made in the past 30 years. This unit can handle both Moving Magnet(MM) and Moving Coil(MC) Cartridges.
DIMENSONS: 5.3V 5 5/16 x 1 15/16 x 2 7/8″
Moving coil specs:
· Input Impedance (R and C): 100 Ohm + 180pF
· Gain at 1kHz: 60dB
· Input Sensitivity (ref. 200mV output): 0.3mV
· Signal to Noise Ratio: 78dB (A weighted, with cartridge connected)
· Input Overload (20Hz/1kHz/20kHz): 0.8/9/84mV
· Rated Distortion (THD 20Hz – 20kHz): <0.03%
· RIAA Response Accuracy: ±0.3dB
Moving Magnet specs:
· Input Impedance (R and C): 47 kilohm + 200pF
· 47 kilohm + 200pF
· Gain at 1kHz: 35dB
· Input sensitivity (ref. 200mV output): 2.5mV
· Signal to Noise Ratio: 80dB (A weighted, with cartridge connected)
· Input overload (20Hz/1kHz/20kHz): /102/950mV
· Rated Distortion (THD 20Hz – 20kHz): <0.03%
· RIAA response accuracy: ±0.3dB
LINE OUT SPECS:
· Output Impedance: 100 Ohm
· Maximum Output Level: 5.3V